Here are some tips to get your home ready for a home inspection.

1. Make sure the electric is on in the home and to all circuits. A home inspector will not flip breakers ?on? or ?off? during an inspection. 2. Make sure the gas or fuel is on to all the appliances and that all pilot lights are lit. Inspectors will not light pilot lights or turn on valves. 3. Make sure water is on and functional to all fixtures. Inspectors will not turn any valves to get water to any fixture. 4. If there are any light bulbs burned out, replace them. 5. Clear out stored items under the sinks. 6. If the attic access is located in a closet or other area where your personal effects are in the way, remove all of your personal items from under the access hole and remove any shelving that may be in the way of getting a ladder to the attic. Inspectors will not move any personal items or shelving to access an attic. 7. Grab a screwdriver and check all doors and windows for loose hardware, and make sure they all open/close properly. 8. Clean off the roof and/or gutters from debris, etc. 9. Check for any minor leaks under sinks or drains under the floor in the basement, etc., and have them repaired prior to the inspection. 10. Have your heating and A/C equipment serviced and have record of the last servicing available for proof.

Taking care of these items will not only reduce the laundry list of defects found on a home inspection report, but it will also help secure the deal to sell your home.

Here are a few sources to locate a home inspector in your area. In Wisconsin: http://wisconsin-home-inspectors.com National http://findaninspector.us http://homeinspections-usa.com

Posted by Paula Garcia on December 13, 2008 at 12:00 AM

About Paula Garcia
Paula Garcia is affliated with Paula and Company Realtors, which is located in Cleveland, OK. For further assistance please use the contact information located on the right.




As of 05/24/12 the Paula Garcia RePage is ranked at 2,315 with 455 points.